European Trade Fair for Machine Technology, Equipment and Supplies for the Wood Crafts

12 - 15 July 2022 // Nuremberg, Germany

POSTPONEMENT: HOLZ-HANDWERK and FENSTERBAU FRONTALE will take place in 2022 from July 12 - 15. More information can be found HERE.

Posting print layout

What information should be shown in the print layout?

Create print layout
Exhibitors & Products HOLZ-HANDWERK 2022
Zoom Image LOGO_Briquette Press

Briquette Press

LOGO_Briquette Press

Briquette Press

Request information Request information

Contact us

Please enter your personal information and desired appointment. You can also leave us a message.

Your personal information

Your message for us

Desired appointment during the exhibition

* Compulsory fields you must fill in.

Information on data protection can be found here.

Your message has been sent.

You do not have a registration yet? Register now and use all advantages of the Exhibitors and Products Database and the TicketShop.

An error has occurred.

The Type KM25 performs approximately 25 - 50 kg/hour (? 55lb/hour). The performance is primary depending on the condition and quality of the chips, what means, the smaller (finer) and harder, the more kg-performance per hour. This Briquette press was especially designed for smaller companies, where the refilling takes place by hand or the press will be placed underneath the chip silo. When the press is placed underneath the silo, it is required that the chips are dropping easily in the hopper of the press. Especially planing- and turning chips have the tendency to build a bridge. If there is frequently a larger amount of these bigger chips, it is recommended to install an additional tamping cylinder, which will transfer the loose material in the prepress room.

The chips are ideally mixed, small and big, hard- and soft wood and with a max. humidity of 13%. The result will be briquettes with a constant hardness and constant length. The maximum humidity of the wood chips is limited to 15%.

If the Briquette press should run fully automated, it can be equipped with a filling-level sensor, which starts the press process as soon as there are chips in the hopper and stops when the material is processed.

The KM50 has approximately the double performance of the KM25 and the tamping cylinder is already standard equipment.

The Briquette presses KM are designed for single shift production. If there is a higher production time required, an additional oil cooler must be installed. This will allow continuous production mode.

The placement of the Briquette press can be underneath a bunker, but never inside a bunker or silo. The waste heat of the hydraulic system must be able to escape and fresh air flow must be given. The electrical switch box and the hydraulic system must be accessible for maintenance work. The switch box has to be dusted periodically.

You decided to attend the HOLZ-HANDWERK? Get your ticket now!


The selected entry has been placed in your favourites!

If you register you can save your favourites permanently and access all entries even when underway – via laptop or tablet.

You can register an account here to save your settings in the Exhibitors and Products Database and as well as in the Supporting Programme.The registration is not for the TicketShop and ExhibitorShop.

Register now

Your advantages at a glance:

  • Advantage Save your favourites permanently. Use the instant access – mobile too, anytime and anywhere – incl. memo function.
  • Advantage The optional newsletter gives you regular up-to-date information about new exhibitors and products – matched to your interests.
  • Advantage Call up your favourites mobile too! Simply log in and access them at anytime.