Wieder Maschinenbau GmbH

Steindorf

Gewerbegebiet Süd 7

5204 Straßwalchen

Austria

Phone: +43(0)6215.7182

Fax: +43(0)6215.7182-13

www.wieder-maschinenbau.at

Request contact / appointment

Hall 9 / 9-200

Products of Wieder Maschinenbau GmbH (5)

LOGO_Brikettierpressen passend für Ihre Absaugung

Exhibitor Profile

Products (5)

Job Offers (0)

WIEDER-Maschinenbau GmbH was founded in 2001 and is located in Salzburg region, which presents a positive economic growth. In April 2002 we acquired the Frischling Maschinenbau GmbH, which had been established on the market since 1987. To continue the excellent reputation of HF-machines we support our customers with machines of the highest quality.

Our strength in hydraulics, mechanics and know-how of special civil engineering allows us to serve our clients with the highest competence and expertise. Apart from standard machines, we also provide special machines on request to meet your individual demands. A wide range of services, from design to installation, is provided. Due to our international activities over the last 15 years and an intact distribution network, our brand has found international acceptance.

Brikettierpressen passend für Ihre Absaugung

Briquette Press

The Type KM25 performs approximately 25 - 50 kg/hour (? 55lb/hour). The performance is primary depending on the condition and quality of the chips, what means, the smaller (finer) and harder, the more kg-performance per hour. This Briquette press was especially designed for smaller companies, where the refilling takes place by hand or the press will be placed underneath the chip silo. When the press is placed underneath the silo, it is required that the chips are dropping easily in the hopper of the press. Especially planing- and turning chips have the tendency to build a bridge. If there is frequently a larger amount of these bigger chips, it is recommended to install an additional tamping cylinder, which will transfer the loose material in the prepress room.

The chips are ideally mixed, small and big, hard- and soft wood and with a max. humidity of 13%. The result will be briquettes with a constant hardness and constant length. The maximum humidity of the wood chips is limited to 15%.

If the Briquette press should run fully automated, it can be equipped with a filling-level sensor, which starts the press process as soon as there are chips in the hopper and stops when the material is processed.

The KM50 has approximately the double performance of the KM25 and the tamping cylinder is already standard equipment.

The Briquette presses KM are designed for single shift production. If there is a higher production time required, an additional oil cooler must be installed. This will allow continuous production mode.

The placement of the Briquette press can be underneath a bunker, but never inside a bunker or silo. The waste heat of the hydraulic system must be able to escape and fresh air flow must be given. The electrical switch box and the hydraulic system must be accessible for maintenance work. The switch box has to be dusted periodically.